Toyota Corolla Cross: Ignition System
READ NEXT:
PARTS LOCATION ILLUSTRATION
*1 ECM
*2 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY
- INJ FUSE *3
IGNITION COIL ASSEMBLY
*4 SPARK PLUG
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
CAUTION: To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and c
SEE MORE:
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the L7 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disc
ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after completing the front wheel alignment procedure are
shown below.
Necessary Procedures After Procedure Performed
Replaced Part or Perfo
Parts Location
Terminals Of Ecu
