Toyota Corolla Cross: Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the GTS to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the DLC3.
Click here
.gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether
DIAGNOSTIC TROUBLE CODE CHART Sliding Roof System
DTC No. Detection Item
DTC Output from Link
B234149 Sliding Roof Motor Internal Electronic Failure
Main Body
DESCRIPTION When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor malfunction and the sliding roof operation is stopped, DTC B234149 is stored.
When the sliding roof ECU (s
SEE MORE:
DESCRIPTION The stop light switch assembly is part of a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. This DTC indicates that the stop light switch assembly remains on. When the stop light
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the immobiliser system.
*: Use the GTS.
PROCEDURE
1. VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
HINT:
In troubleshooting, confirm t
