Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE PARKING SUPPORT BRAKE SYSTEM

(a) Customizing with the GTS.

Clearance Warning

Tester Display

Description

Default

Setting

ECU

PKSB (O) Function

Parking support brake (static objects) function setting

ON

$00:ON,$01:OFF

Clearance warning ECU assembly

PKSB (O) Target Stopping Distance

Stop distance status of parking support brake (static objects) function

Far

$00:Close,$01:Far

Clearance warning ECU assembly

PKSB Switch State Stored

Setting of the parking support brake system main switch status memory

Stored

$00:Stored,$01:Not Stored

Clearance warning ECU assembly

PKSB (V) Function

Parking support brake (rear crossing vehicles) function setting

ON

$00:ON,$01:OFF

Clearance warning ECU assembly

PKSB (V) Operation Timing Setting

Displays the operation timing setting of the parking support brake (rear crossing vehicles) function

Standard

$00:Late,$01:Standard

Clearance warning ECU assembly

PKSB (V) Sensitivity

Displays the sensitivity setting of the parking support brake (rear crossing vehicles) function

Standard

$00:Standard,$01:Low

Clearance warning ECU assembly

    READ NEXT:

     Calibration

    CALIBRATION NOTICE: When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the parking support brake system may not operate correctly. PREC

     Utility

    UTILITY HINT: With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS You should check "All Readiness" after simulating

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is u

    SEE MORE:

     Evaporator Temperature Sensor Circuit Short to Ground (P053511)

    DESCRIPTION The No. 1 cooler thermistor is installed to the evaporator in the air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the air conditioning amplifier assembly. Th

     Inspection

    INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL ECU HINT: If the results of the following inspections are as specified but a malfunction has occurred, replace the shift lock control unit assembly. (a) Inspect wire harness: (1) Disconnect the shift lock control ECU connector.

    © 2020-2025 Copyright www.tcorollacross.com PT NL