Toyota Corolla Cross: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE TELEMATICS SYSTEM
(a) Customizing with the GTS.
NOTICE:
- When the customer requests a change in a function, first make sure that
the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is
set to the default setting.
- When adjusting the telematics microphone volume, please verity sound
volume with the call before taking the vehicle back to customer.
(1) Select the setting by referring to the table below.
Others
|
Tester Display
|
Description
|
Default
|
Setting
|
ECU
|
|
Telematics Microphone Volume Adjust
|
Sets the telephone microphone assembly volume
|
6
|
$01:1(MIN),$02:2,$03:3,$04:4,$05:5,$06:6,$07:7,$08:8,$09:9,$0A:10,$0B:11(MAX)
|
DCM (telematics transceiver)
|
|
Telematics Speaker Volume Adjust
|
Sets the speaker volume
|
11
|
$01:1(MIN),$02:2,$03:3,$04:4,$05:5,$06:6,$07:7,$08:8,$09:9,$0A:10,$0B:11,$0C:12,$0D:13,$0E:14(MAX)
|
DCM (telematics transceiver)
|
READ NEXT:
INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery (mobilephone battery) has been replaced,
it is necessary to perform the Reset Backup Battery Condition procedure.
(a)
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed i
TERMINALS OF ECU
CHECK DCM (TELEMATICS TRANSCEIVER)
Terminal No. (Symbol)
Terminal Description
Condition
Specified Condition
I200-1 (+B
SEE MORE:
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that magnetic force deterioration of the permanent magnet located in the rotor inside the rear motor (MGR) has been detected. The cause of this malfunction may be one of the following:
Area Main Malfunction Description
Inverter
Before Disconnecting Battery
BEFORE DISCONNECTING BATTERY
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for
HEV Model)
Depending on the "ACC customize" setting, the background will remain started
even when the ignition switch is turned off. For that