Toyota Corolla Cross: Initialization
INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery (mobilephone battery) has been replaced,
it is necessary to perform the Reset Backup Battery Condition procedure.
(a) Enter the following menus:
Body Electrical > Telematics > Utility
|
Tester Display
|
|
Backup Battery Replacement Reset
|
(b) According to the display on the GTS, perform Backup Battery
Replacement Reset to reset the mobilephone battery replacement flag.
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed i
TERMINALS OF ECU
CHECK DCM (TELEMATICS TRANSCEIVER)
Terminal No. (Symbol)
Terminal Description
Condition
Specified Condition
I200-1 (+B
DIAGNOSIS SYSTEM
DESCRIPTION
(a) The DCM (telematics transceiver) control the vehicle safety
connect system functions. Safety connect system data and Diagnostic Trouble Codes
(DTCs) can be read
SEE MORE:
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC is stored when an abnormal current sensor output signal is detected. The cause of this malfunction may be one of the following: Internal inverter malfunction
Current sensor malfunction
Inverter with converter assembly internal circuit malfunct
OPERATION CHECK CHECK SRS WARNING LIGHT (a) Primary check
(1) Turn the ignition switch to ON and check that the SRS warning light turns on.
(2) Turn the ignition switch off. Wait for at least 2 seconds, then turn the ignition switch to ON. The SRS warning light comes on for approximately 6 seco
