Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Camera Malfunction System Internal Failure (C161704)

Toyota Corolla Cross (2022-2025) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System / Camera Malfunction System Internal Failure (C161704)

DESCRIPTION

This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C161704

Camera Malfunction System Internal Failure

ECU internal malfunction

Rear television camera assembly

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click here

PROCEDURE

1.

REPLACE REAR TELEVISION CAMERA ASSEMBLY

(a) Replace the rear television camera assembly with a new one.

HINT:

Click here

NEXT

END

    READ NEXT:

     Lost Communication with ECM/PCM "A" Missing Message (U010087,U012687,U012987,U014087,U016387,U029387)

    DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU. HINT: If CAN communication system DTCs are stored, they may also b

     Image from Camera for Parking Assist Monitor is Abnormal

    DESCRIPTION The display signal from the rear television camera assembly is transmitted to the display. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced

     Parking Support Brake System

    SEE MORE:

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE If DTCs are not output but the malfunction persists, use the following table to determine which circuits to inspect for each problem symptom. HINT: Refer to each inspection procedure for related problem symptoms. Electronically Controlled Brake System Symptom

     Electronic Circuit Inspection Procedure

    ELECTRONIC CIRCUIT INSPECTION PROCEDURE BASIC INSPECTION (a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS (1) Unless otherwise stated, all resistance measurements are standard values measured at an ambient temperature of 20°C (68°F). Resistance measurements may be inaccurate if measured at

    © 2020-2025 Copyright www.tcorollacross.com