Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Brake Switch "A" Circuit Open (P057113)

DESCRIPTION

When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (brake booster with master cylinder assembly) operates the stop light switch assembly (stop light control relay) to illuminate the stop lights.

If the hybrid vehicle control ECU receives a signal from the skid control ECU (brake booster with master cylinder assembly) indicating a malfunction of the stop light control relay, DTC P057113 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

Note

P057113

Brake Switch "A" Circuit Open

When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects a signal indicating a stop light control relay malfunction from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more.

(1 trip detection logic)

Electronically controlled brake system

Does not come on

Master Warning:

Does not come on

SAE Code:

P0571

PROCEDURE

1.

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM

HINT:

If DTC P057113 is output by the dynamic radar cruise control system, perform troubleshooting for the electronically controlled brake system first.

Click here

NEXT

END

    READ NEXT:

     Hybrid/EV Powertrain Control Module Processor Watchdog / Safety MCU Failure (P060647,...,P1CE371)

    DESCRIPTION The hybrid vehicle control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction. If these DTCs are output, replace the hybrid vehicle contr

     High Voltage System Interlock Circuit Open (P0A0A13,P0A0A92)

    DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects that a safety device (interlock) is operated or that there is an open circuit in the detection circuit. (Even if an open circ

     Drive Motor "B" Control Module Unexpected Operation (P0A1C94)

    DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU monitors the motor generator control ECU (MG ECU). The cause of this malfunction may be the following: Motor generator control ECU

    SEE MORE:

     Checking Monitor Status

    CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalysts and evaporative emissions (EVAP) systems. The monitor result allo

     Ignition Circuit

    DESCRIPTION A direct ignition system is used on this vehicle. The direct ignition system is a 1 cylinder ignition system which ignites one cylinder with one ignition coil. In the 1 cylinder ignition system, one spark plug is connected to the end of the secondary winding. High voltage is generated in

    © 2020-2025 Copyright www.tcorollacross.com PT NL