Toyota Corolla Cross: AWD Warning does not Come ON
DESCRIPTION
Refer to "AWD Warning Light Remains ON".
Click here .gif)
WIRING DIAGRAM
Refer to "AWD Warning Light Remains ON".
Click here
CAUTION / NOTICE / HINT
Refer to "AWD Warning Light Remains ON".
Click here
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR |
(a) Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.
OK:
No looseness at the locking and connecting parts
(b) Disconnect the O201 4WD ECU assembly connector.
(c) Check the connector case and the terminal for deformation and corrosion.
OK:
No deformation or corrosion
(d) Connect the O201 4WD ECU assembly connector.
| NG | .gif) |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
.gif)
|
2. |
CHECK 4WD WARNING MESSAGE |
(a) According to the display on the GTS, read the Data List.
Chassis > Four Wheel Drive > Data List|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
4WD Warning Light |
AWD warning (multi-information display) |
OFF or ON |
OFF: Warning off ON: Warning on |
- |
|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
4WD Warning Light |
AWD warning (multi-information display) |
OFF / ON |
Observe combination meter assembly |
|
Active Test Display |
|---|
|
4WD Warning Light |
|
Data List Display |
|---|
|
4WD Warning Light |
|
Result |
Proceed to |
|---|---|
|
Data List display does not switch ON/OFF |
A |
|
Data List display switches ON/OFF |
B |
| A | |
REPLACE 4WD ECU ASSEMBLY |
| B | |
GO TO METER / GAUGE SYSTEM |
