Toyota Corolla Cross: Automatic Light Control Sensor
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the h1 automatic light control sensor connector.
(b) Measure the voltage and resistance according to the
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 INSTRUMENT PANEL SAFETY PAD ASSEMBLY
55400 -
- -
2 AUTOMATIC LIG
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 AUTOMATIC LIGHT CONTROL SENSOR
89120A -
- -
2 INSTRUME
SEE MORE:
CALIBRATION
ADJUST PARKING ASSIST MONITOR SYSTEM
(a) The parking assist monitor system can be adjusted using diagnostic
mode.
(b) If the following operations are performed, it is necessary
to perform adjustments and checks using diagnostic mode.
Part Name
Operation
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are
reference values. Do not depend solely on these reference values when deciding whether
a part is faulty or not.
DATA LIST
HINT:
Using the GTS to read the Data List allows the values
On-vehicle Inspection
Calibration
