Toyota Corolla Cross: Transfer Case Front Oil Seal (for Lh Side)
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
TRANSFER CASE OIL SEAL
-
-
●
Non-reusable part
MP grease
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced du
Components
COMPONENTS
ILLUSTRATION
*1
DRIVE SHAFT BEARING BRACKET
*2
TRANSFER CASE OIL SEAL RH
Tightening torque for "
SEE MORE:
INITIALIZATION
NOTICE:
Initialization can be confirmed through the tire pressure warning light.
If the ignition switch is turned off during initialization, the tire pressure
warning ECU and receiver memorizes that initialization was being performed.
Therefore, it is not necessary to
PROCEDURE
1.
PERFORM ROAD TEST
(a) After turning the ignition switch to ON, compare the operating
sound of the brake actuator the first time the vehicle speed reaches 45 km/h (28
mph) with a known good vehicle of the same model.
OK:
The operating sound is the
Components
Initialization
