Toyota Corolla Cross: Throttle Body
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (a) Before cleaning, or after cleaning the throttle body with motor assembly and installing it to the vehicle, turn the p
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 DRAIN ENGINE COOLANT
- -
- 2
AIR CLEANER CAP WIT
INSPECTION PROCEDURE 1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Con
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD)
(a) Preparation for check. (1) Confirm the standard, high and low positions of the link that will be used in the following inspection.
The standard position is 53° from the maximum link angle (high) and 113° f
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 OUTER MIRROR SWITCH ASSEMBLY
84870A -
- -
2 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL
- -
- -
On-vehicle Inspection
Inspection
