Toyota Corolla Cross: Stop Light Switch
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the A53 stop light switch assembly connector.
(b) Measure the voltage and resistance on the wire harness side
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55606 -
- -
2 NO
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 STOP LIGHT SWITCH MOUNTING ADJUSTER
84345 -
- -
2 STOP
SEE MORE:
INITIALIZATION INITIALIZE MULTIPLEX NETWORK DOOR ECU
NOTICE: Initialization of the multiplex network door ECU (back door initial position learning) is necessary if the following work procedures are performed while the back door is open.
The cable to the negative (-) auxiliary battery terminal is
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 DECK TRIM SIDE PANEL ASSEMBLY LH
64740C -
- -
2 ROOF SIDE INNER GARNISH ASSEMBLY LH
62480A -
- -
3 DOOR CONTROL AND TIRE PRESSURE
On-vehicle Inspection
Initialization
