Toyota Corolla Cross: Steering Angle Sensor
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
INSPECT SPIRAL CABLE SUB-ASSE
Inspection
INSPECTION
PROCEDURE
1. INSPECT VSC OFF SWITCH (COMBINATION SWITCH ASSEMBLY)
(a) Make sure that there is no looseness in the locking part
and the connecting part of the
SEE MORE:
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here
3. SEPARATE REAR FLEXIBLE HOS
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT
Removal
On-vehicle Inspection
