Toyota Corolla Cross: Shift Lever Position Sensor
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
SECURE VEHICLE
-
INSPECTION
PROCEDURE
1. INSPECT SHIFT LEVER POSITION SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester C
ADJUSTMENT
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
Make sure to apply the parking brake and chock a wheel before performing
this procedure.
SEE MORE:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (a) Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Standard: Washer fluid contacts the windshield in the areas shown in the illustration.
*a Upper Limit
DESCRIPTION In this circuit, the compressor with pulley assembly receives refrigerant compression demand signals from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly changes the amount of compressor output.
DTC No. Detection Item
DTC
Removal
On-vehicle Inspection
