Toyota Corolla Cross: Service Plug Grip
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 CHECK FOR DTC
- -
-
2 NEGATIVE AUXILIA
INSPECTION PROCEDURE 1. INSPECT SERVICE PLUG GRIP
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 SERVICE PLUG GRIP
G3834
- -
2
SEE MORE:
MONITOR DESCRIPTION The ECM continuously monitors its internal ICs and the monitor IC. If the monitor IC is abnormal, the ECM illuminates the MIL and stores DTC P060747. If an internal IC is abnormal, the ECM illuminates the MIL and stores DTC P060787.
DTC No. Detection Item
DTC Detecti
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the GTS once the inspection has
been completed.
Do not apply excessive force to the millimeter wave radar sensor assembly
connector.
CHEC
Removal
Control Module Performance Bank 1 Watchdog/Safety MCU Failure (P060747,P060787)
