Toyota Corolla Cross: Registration
REGISTRATION
PROCEDURE
1. ASSIGNING SETTINGS
NOTICE:
Make sure to complete driver registration before assigning settings.
|
Procedure | Steps |
|
1. Assigning settings (electrical key transmitter sub-assembly) |
- Bring the electrical key transmitter sub-assembly for which to assign settings inside the vehicle.
- On the screen of the multi-display, select "Settings" → "Personal info" → "Link key".
- Wait momentarily.
- Confirm that settings have completed.
NOTICE: Settings cannot be assigned to an electrical key transmitter sub-assembly that already has settings assigned for another driver. |
|
2. Assigning settings (Bluetooth key)*1 |
- Connect the Bluetooth device for which to assign settings to the multi-display.
- On the screen of the multi-display, select "Settings" → "Personal info" → "Link devices" or "Change link devices".
- In accordance with the screen of the multi-display, assign settings to the Bluetooth device.
- Confirm that settings have completed.
NOTICE: Settings cannot be assigned to a Bluetooth that already has settings assigned for another driver. |
- *1: for Vehicles which display the assigned settings of Bluetooth devices on the multi-display
2. ASSIGNMENT CLEARANCE
|
Procedure | Steps |
|
1. Assignment clearance (electrical key transmitter sub-assembly) |
- On the screen of the multi-display, select "Settings" → "Personal info" → "Link key", and delete the settings.
|
| 2. Assignment clearance (bluetooth device)*1 |
- On the screen of the multi-display, select "Settings" → "Personal info" → "Link devices" or "Change link devices" and delete the settings.
|
- *1: for Vehicles which display the assigned settings of Bluetooth devices on the multi-display
READ NEXT:
CUSTOMIZE PARAMETERS INSTALL CUSTOMIZE MY SETTINGS SYSTEM
HINT: The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that the funct
PROBLEM SYMPTOMS TABLE NOTICE: There are some components for which it is necessary to set settings when replaced or removed and installed.
Click here My Settings System
Symptom Suspected A
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe
SEE MORE:
DESCRIPTION
Refer to DTC C050C12
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C050C14
Left Rear Wheel Speed Sensor Circuit Short to Ground
or Open
A short or open circuit is detected
The emergency flashers are
used to warn other drivers
when the vehicle has to be
stopped on the road due to
a breakdown, etc.
Operating instructions
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
■Emergency flashers
If the emergency fla
