Toyota Corolla Cross: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
There are some components for which it is necessary to set settings when replaced or removed and installed.
Click here .gif)
My Settings System
|
Symptom | Suspected Area |
Link |
| My setting cannot be recalled |
Refer to the "My Setting cannot be Recalled' |
|
|
Driver identification method cannot be set |
Refer to the "Driver Identification Method cannot be Set" |
|
|
Driver identification method cannot be clear |
Audio and Visual System |
|
|
Main Body ECU (Multiplex Network Body ECU) |
|
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe
VEHICLE CONTROL HISTORY (RoB)
NOTICE:
If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before vehicle control hi
DESCRIPTION It may be possible to determine the cause of the problem by the customize setting items which are not recalled or type of registered device for which a recall is not performed. If all cust
SEE MORE:
DESCRIPTION In this circuit, the compressor with pulley assembly receives refrigerant compression demand signals from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly changes the amount of compressor output.
DTC No. Detection Item
DTC
DESCRIPTION HINT: These DTCs relate to the accelerator pedal position sensor.
The accelerator pedal position sensor is built into the accelerator pedal sensor assembly and has 2 sensor circuits: VPA (main) and VPA2 (sub). This sensor is a non-contact type sensor and uses Hall-effect elements in or
