Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Rear Side Radar Sensor (Module "B") System Internal Failure (C1AB604)

Toyota Corolla Cross (2022-2026) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Blind Spot Monitor System / Rear Side Radar Sensor (Module "B") System Internal Failure (C1AB604)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH (B) detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB604

Rear Side Radar Sensor (Module "B") System Internal Failure

The blind spot monitor sensor LH (B) detects an internal malfunction

Blind spot monitor sensor LH (B)

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.

CHECK DTC

(a) Turn the ignition switch off.

(b) Turn the ignition switch to ON.

(c) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor "B" > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR LH (B)

    READ NEXT:

     Rear Side Radar Sensor (Module "A") System Internal Failure (C1AB704)

    DESCRIPTION This DTC is stored when the blind spot monitor sensor RH (A) detects an internal malfunction. DTC No. Detection Item DTC Detection Condition

     Rear Side Radar Sensor (Module "B") Beam Axis Misalignment (Horizontal) (C1AC100)

    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH (B) deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedome

     Rear Side Radar Sensor (Module "A") Beam Axis Misalignment (Horizontal) (C1AC200)

    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH (A) deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedome

    SEE MORE:

     Brake Switch "A" Circuit Short to Battery (P057112)

    DESCRIPTION The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied. DTCs may be stored if either of the following occurs: Stop light switch assembly stuck on malfunction. The accelerator

     Registration

    REGISTRATION PROCEDURE 1. REPAIR INSTRUCTION CAUTION: As weak radio waves are emitted from the electrical key transmitter sub-assembly, if a pacemaker is being used, be sure to read the pacemaker instruction manual and the following. People with implantable cardiac pacemakers, cardiac resynch

    © 2020-2026 Copyright www.tcorollacross.com PT NL