Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Rear Side Radar Sensor (Module "A") System Internal Failure (C1AB704)

Toyota Corolla Cross (2022-2025) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Blind Spot Monitor System / Rear Side Radar Sensor (Module "A") System Internal Failure (C1AB704)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH (A) detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB704

Rear Side Radar Sensor (Module "A") System Internal Failure

The blind spot monitor sensor RH (A) detects an internal malfunction

Blind spot monitor sensor RH (A)

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.

CHECK DTC

(a) Turn the ignition switch off.

(b) Turn the ignition switch to ON.

(c) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor "A" > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR RH (A)

    READ NEXT:

     Rear Side Radar Sensor (Module "B") Beam Axis Misalignment (Horizontal) (C1AC100)

    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH (B) deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedome

     Rear Side Radar Sensor (Module "A") Beam Axis Misalignment (Horizontal) (C1AC200)

    DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH (A) deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedome

     Lost Communication with ECM/PCM "A" Missing Message (U010087,U012687,U012987,U014087,U029387,U111087)

    DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor. HINT: If CAN communication system DTCs are stored, they may

    SEE MORE:

     Entry Exterior Alarm and Answer-back Buzzer do not Sound

    DESCRIPTION The smart key system (for Entry Function) uses the wireless door lock buzzer to perform various vehicle exterior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the main body ECU (multiplex

     All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch

    DESCRIPTION The main body ECU (multiplex network body ECU) receives switch signals from the door control switch assembly. The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the m

    © 2020-2025 Copyright www.tcorollacross.com PT NL