Toyota Corolla Cross: Rear Drive Shaft Assembly (for M20a-fks)
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
DRAIN DIFFERENTIAL OIL
-
DISASSEMBLY
CAUTION / NOTICE / HINT
COMPONENTS (DISASSEMBLY)
Procedure
Part Name Code
1
REAR NO. 2 DRIVE SHAFT INBOARD
INSPECTION
PROCEDURE
1. INSPECT REAR DRIVE SHAFT ASSEMBLY
(a) Check that there is no excessive play in the radial direction of
the outboard joint.
SEE MORE:
MONITOR DESCRIPTION The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned off. If the output voltage is 7 V or higher when the ignition switch is turned off, the
DESCRIPTION
The brake hold standby indicator light turns on if brake hold
control is possible when the following conditions required for operation standby
are met and the brake hold switch (electric parking brake switch assembly) is pressed
while the ignition switch is ON.
Conditions requ
Removal
Actuator Supply Voltage "A" Stuck On (P06579E)
