Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Rear Axle Hub (for Awd)

READ NEXT:

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL Click

 Removal

REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 REAR WHEEL - -

 Installation

INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 REAR AXLE HUB AND BEARING ASS

SEE MORE:

 Steering Angle Sensor Module Circuit Voltage Out of Range (C05261C)

DESCRIPTION The skid control ECU (brake actuator assembly) compares the calculated steering angle value based on the yaw rate sensor value with the actual steering angle value of the steering sensor. DTC No. Detection Item DTC Detection Condition Tro

 Cold Start Idle Control System Performance (P050A00)

MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 (14°F) or higher, and less than 50°C (122°F). If certain conditions are met, a DTC will be stored after the engine idles for 15 seconds (2 trip detection logic). This DTC is designed to mon

© 2020-2026 Copyright www.tcorollacross.com PT NL