Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Propeller Shaft System

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Propeller Shaft System

Symptom

Suspected Area

Link

Noise or Vibration

Center bearing (worn)

Propeller shaft (runout)

    READ NEXT:

     Rear Drive Shaft Assembly (for M20a-fks)

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 DRAIN DIFFERENTIAL OIL -

     Disassembly

    DISASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (DISASSEMBLY) Procedure Part Name Code 1 REAR NO. 2 DRIVE SHAFT INBOARD

    SEE MORE:

     Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Ground (P011011)

    DESCRIPTION The intake air temperature sensor, mounted on the mass air flow meter sub-assembly, monitors the intake air temperature. The intake air temperature sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the intake air temper

     Engine Coolant Temperature Sensor 1 Circuit Short to Battery or Open (P011515)

    DESCRIPTION Refer to DTC P011511. Click here HINT: When DTC P011515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected. DTC No. Detection

    © 2020-2025 Copyright www.tcorollacross.com PT NL