Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Precaution

PRECAUTION

INITIALIZATION

NOTICE:

  • Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the cable has been disconnected from the negative (-) battery terminal.
    1. When parts related to the charging system have been removed/installed or replaced:

      Click here

CHARGING SYSTEM PRECAUTION

NOTICE:

  • Check that the battery cables are connected to the correct terminals.
  • Disconnect the battery cables when the battery is given a quick charge.
  • Do not perform tests with a high voltage insulation resistance tester.
  • Never disconnect the battery cables while the engine is running.
  • Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the No. 1 engine room relay block.

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 GENERATOR ASSEMBLY *2 ECM *3 BATTERY STATE SENSOR ASSEMBLY *4 NO. 1 ENG

     System Diagram

    SYSTEM DIAGRAM

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

    SEE MORE:

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 REAR AXLE CARRIER SUB-ASSEMBLY 42305 - - 2 REAR TRAILIN

     Registration

    REGISTRATION PROCEDURE 1. BEFORE REGISTRATION NOTICE: The transmitter ID is written on the tire pressure warning valve and transmitter. It is not possible to read the transmitter ID after installing the tire onto the wheel. Therefore, make a note of the transmitter ID before installing

    © 2020-2026 Copyright www.tcorollacross.com PT NL