Toyota Corolla Cross: Passenger Seat Occupant Classification Sensor "A" Component Internal Failure (B00C096)
DESCRIPTION
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Warning Indicate | Test Mode / Check Mode |
B00C096 | Passenger Seat Occupant Classification Sensor "A" Component Internal Failure |
Front occupant classification sensor LH malfunction |
Front occupant classification sensor LH (Front Seat Cushion Spring Sub-assembly RH)* |
Comes on | Does not apply to test/check mode |
- *: The front occupant classification sensor LH is built into the front seat cushion spring sub-assembly RH.
PROCEDURE
(a) Clear the DTCs stored in memory.
Body Electrical > SRS Airbag > Clear DTCs
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ON, and wait for at least 60 seconds.
NEXT |
| |
(a) Check for DTCs.
Body Electrical > SRS Airbag > Trouble Codes
Result | Proceed to |
B00C096 is output | A |
B00C096 is not output |
B |
HINT:
Codes other than DTC B00C096 may be output at this time, but they are not related to this check.
A |
| REPLACE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY RH |
B |
| USE SIMULATION METHOD TO CHECK |
READ NEXT:
DESCRIPTION DTC B00C228 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident did not occur.
DTC No. Detection Item
DTC Detection Cond
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B00C286 Passenger Seat Occupant Classification Sensor "C
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B00C287 Passenger Seat Occupant Classification Sensor "C
SEE MORE:
PRECAUTION PRECAUTIONS WHEN USING GTS (a) When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under
DESCRIPTION If recirculation/fresh mode changes unintentionally and without permission, the following causes are possible.
Symptom Factor
Recirculation/fresh mode changes without permission
Recirculation/fresh mode light blinks
Customize setting
Chan