Toyota Corolla Cross: Park / Neutral Position Switch
READ NEXT:
ON-VEHICLE INSPECTION
PROCEDURE
1. SECURE VEHICLE
(a) Fully apply the parking brake and chock a wheel.
CAUTION:
Make sure to apply the parking brake and chock a wheel before performing
this
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
SECURE VEHICLE
-
INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
SEE MORE:
DESCRIPTION Refer to DTC P011011. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P01102A Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range
Either of the following conditions is met (2 trip detection logic):
DESCRIPTION Refer to DTC P011011. Click here
HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the ignition switch is the
On-vehicle Inspection
Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range (P01102A)
