Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Operation Check

Toyota Corolla Cross (2022-2026) Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System / Operation Check

OPERATION CHECK

CHECK ELECTRICAL REMOTE CONTROL MIRROR FUNCTION

(a) Turn the ignition switch to ON.

(b) With L on the mirror select and mirror adjust switch selected, check that the outer rear view mirror assembly LH surface moves up, down, left and right normally.

(c) With R on the mirror select and mirror adjust switch selected, check that the outer rear view mirror assembly RH surface moves up, down, left and right normally.

CHECK MIRROR HEATER FUNCTION

(a) Turn the ignition switch to ON.

(b) Check that pressing the mirror heater switch (rear window defogger switch) illuminates the indicator and warms the mirror surfaces.

(c) Check that after approximately 15 minutes, the indicator light turns off and the mirror heaters deactivate.

    READ NEXT:

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE NOTICE: If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. I

     Terminals Of Ecu

    TERMINALS OF ECU CHECK POWER DISTRIBUTION BOX ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU). Click here *1 Power Dist

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a p

    SEE MORE:

     Disassembly

    DISASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (DISASSEMBLY) Procedure Part Name Code 1 SHIFT LEVER HOUSING BRACKET SUB-ASSEMBLY 33507 - - PROCEDURE 1. REMOVE SHI

     Stop And Start System Cancel Switch Assembly

    InspectionINSPECTION PROCEDURE 1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY (COMBINATION SWITCH ASSEMBLY) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition I61-8 (ERC)

    © 2020-2026 Copyright www.tcorollacross.com PT NL