Toyota Corolla Cross: Operation Check
OPERATION CHECK
ACOUSTIC VEHICLE ALERTING SYSTEM OPERATION CHECK
(a) System operation check (vehicle being driven)
(1) Turn the ignition switch to ON (READY).
(2) Operate the EV drive mode switch and drive the vehicle using EV drive mode.
(3) Change the shift state from park (P) to drive (D) and confirm that the acoustic vehicle alerting system operates (produces a sound) when the vehicle is driven at speeds of 35 km/h (22 mph) or less using EV drive mode.
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU CHECK VEHICLE APPROACHING SPEAKER CONTROLLER
(a) Disconnect the I256 vehicle approaching speaker controller connector.
(b) Measure the voltage and resistance according to the value
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a p
SEE MORE:
Constant speed cruising:
When there are no vehicles ahead
The vehicle drives at the speed set by the driver.
If the set vehicle speed is exceeded while driving down a hill, the set vehicle
speed display will blink and a buzzer will sound.
Deceleration and follow-up cruising:
When a precedin
DESCRIPTION The air conditioner pressure sensor, which is installed to the high pressure side pipe to detect refrigerant pressure, sends a refrigerant pressure signal to the air conditioning amplifier assembly. The air conditioning amplifier assembly converts this signal to a pressure value accordin
