Toyota Corolla Cross: Operation Check
OPERATION CHECK
STOP AND START SYSTEM OPERATION CHECK
HINT:
- If the cable is disconnected from the auxiliary battery terminal, stop and start control is prohibited until refresh charge is completed.
In this case, let the vehicle idle to complete the refresh charge. The refresh charge is complete when the Data List item Status of Battery Charge Control changes from "Refresh Charge Mode". (Usually, by idling the engine for 5 to 60 minutes with the auxiliary battery fluid temperature at 11°C (52°F) or higher, the refresh charge will be completed.)
- If the GTS is not available and the Data List item Status of Battery Charge Control cannot be checked, charge the auxiliary battery by idling the engine for approximately 5 to 60 minutes or driving the vehicle, and then drive the vehicle and check that stop and start control operates.
If the engine is started with the hood open, the system determines that a jump start has occurred. Therefore, make sure that the hood is closed before starting the engine and driving the vehicle.
- After the refresh charge completes, turn the ignition switch off, wait for at least 30 seconds, and then start the engine again. If the vehicle enters refresh charge mode again while the engine is idling, the initial refresh charge did not properly complete, so wait for the refresh charge to complete.
(a) Start the engine and warm it up.
(b) Turn the air conditioning system off.
(c) Drive the vehicle at 7 km/h (4 mph) or more.
CAUTION:
When performing Confirmation Driving Pattern, obey all speed limits and traffic laws.
(d) Depress the brake pedal and stop the vehicle.
(e) Allow the engine to stop by stop and start control. (Keep the shift lever in D.)
(f) Release the brake pedal with the shift lever in D to start the engine.
READ NEXT:
REGISTRATION PROCEDURE 1. ECU EXCHANGE
NOTICE:
When replacing the engine stop and start ECU, make sure to download the number of starter operations (step 1). After replacing the engine stop and
PROBLEM SYMPTOMS TABLE Stop and Start System
Symptom Suspected Area
Link
Stop and start system does not operate
Refer to "Stop and Start System does not Operate"
TERMINALS OF ECU ENGINE STOP AND START ECU
(a) Disconnect the engine stop and start ECU connectors.
(b) Measure the resistance and voltage according to the value(s) in the table below.
Term
SEE MORE:
DESCRIPTION The occupant classification system detects the front passenger seat condition. It then displays the instrument panel passenger without door airbag assembly and front seat cushion spring sub-assembly RH condition (activated/not activated) using the passenger airbag ON/OFF indicator.
HIN
Carry out the necessary
preparations and inspections
before driving the
vehicle in winter. Always
drive the vehicle in a manner
appropriate to the prevailing
weather conditions.
Pre-winter preparations
Use fluids that are appropriate
to the prevailing outside temperatures.
Engine oil
Engine c