Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Problem Symptoms Table

Toyota Corolla Cross (2022-2026) Service Manual / Engine & Hybrid System / Stop And Start / Stop And Start System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

Stop and Start System

Symptom

Suspected Area

Link

Stop and start system does not operate

Refer to "Stop and Start System does not Operate"

Refer to "Stop and Start System does not Operate (Battery Condition)"

Restarting after a short period of time from an idling stop

Refer to "Restarting after a Short Period of Time from an Idling Stop"

After engine stops due to stop and start system, engine does not restart

Refer to "After Engine Stops due to Stop and Start System, Engine does not Restart"

Failure to restart from IG-ON engine stall

Refer to "Failure to Restart from IG-ON Engine Stall"

Stop and start cancel indicator does not operate

Combination meter assembly

Indicator circuit (CAN communication system)

Engine stop and start ECU

Stop and start indicator does not operate

Combination meter assembly

Indicator circuit (CAN communication system)

Engine stop and start ECU

Stop and start control cannot be canceled

ECAN terminal voltage

Stop and start cancel switch circuit

Multi-information display screen does not change after pressing steering pad switch assembly.

Stop and start priority control system

Multi-information display screen changes without pressing steering pad switch assembly.

Stop and start priority control system

Multi-information display screen does not change but control mode changes.

Stop and start priority control system

Multi-information display screen changes but control mode does not change.

Stop and start priority control system

Control mode returns to default mode after turning ignition switch to ON

Stop and start priority control system

    READ NEXT:

     Terminals Of Ecu

    TERMINALS OF ECU ENGINE STOP AND START ECU (a) Disconnect the engine stop and start ECU connectors. (b) Measure the resistance and voltage according to the value(s) in the table below. Term

     Diagnosis System

    DIAGNOSIS SYSTEM DESCRIPTION When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading vario

     Dtc Check / Clear

    DTC CHECK / CLEAR OUTLINE After clearing current DTCs using the GTS (or by disconnecting the cable from the negative (-) auxiliary battery terminal), permanent DTCs can be cleared when the univer

    SEE MORE:

     Lost Communication with Air Inlet Damper Control Servo Motor LIN Missing Message (B143A87)

    DESCRIPTION The air conditioning harness assembly and No. 1 air conditioning radiator damper servo sub-assembly connect the air conditioning amplifier assembly and the No. 1 blower damper servo sub-assembly. The air conditioning amplifier assembly supplies power and sends operation instructions to N

     Check Mode Procedure

    CHECK MODE PROCEDURE DESCRIPTION (a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions that cannot be detected in normal mode. Check mode can also detect all of the malfunctions that can be detected in normal mode. In check mode, DTCs are stored with 1-trip dete

    © 2020-2026 Copyright www.tcorollacross.com PT NL