Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
(a) When the ignition switch is turned to ON, check that the ABS warning
light, brake system warning light (red indicator), slip indicator light, VSC OFF
indicator light, brake hold standby indicator light and brake hold operated indicator
light come on for approximately 3 seconds.
HINT:
If the warning lights and indicator lights do not illuminate or
illuminate for more than approximately 3 seconds, perform troubleshooting for the
electronically controlled brake system.
Click here .gif)
READ NEXT:
VEHICLE CONTROL HISTORY (RoB)
DESCRIPTION
Vehicle Control History (RoB) is a function that captures and stores
ECU data when triggered by specific vehicle behavior.
It may be possible to d
DESCRIPTION
The brake pedal load sensing switch (brake pedal support assembly)
turns on when the brake pedal is depressed with a force exceeding a predetermined
level.
The skid control ECU (brak
DESCRIPTION
Refer to DTC C004013.
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C00409E
Brake Peda
SEE MORE:
DESCRIPTION The battery ECU assembly monitors its internal operation and will store these DTCs when it detects an internal malfunction. If these DTCs are output, replace the battery ECU assembly.
DTC No. Detection Item
DTC Detection Condition
Trouble Area MIL
Warning Ind
OPERATION CHECK CHECK BASIC OPERATIONS NOTICE:
Using the multi-information display (combination meter assembly), check that the rear seat reminder function is set to ON.
Click here
HINT:
Use the same procedure as for the RH side.
If a higher priority notification is displayed on the
