Toyota Corolla Cross: Noise Filter
READ NEXT:
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT RADIO SETTING CONDENSER
(a) With the radio setting condenser installed, check that there is
no looseness or other abnormalities.
(b) Measure
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
DECK TRIM SIDE PANEL ASSEMBLY LH
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
RADIO SETTING CONDENSER
SEE MORE:
PRECAUTION
SENSOR EXPRESSIONS
(a) The descriptions for the blind spot monitor sensors differ
depending on the system. The expressions listed in the table below are used in this
Repair Manual.
Part Name
Actual Part Name
Blind spot monitor sensor LH (B)
When using a floor jack, follow
the instructions in the
manual provided with the
jack and perform the operation
safely.
When raising your vehicle
with a floor jack, position
the jack correctly. Improper
placement may damage
your vehicle or cause injury.
Location of the jack point
■ Front
■ Rea
On-vehicle Inspection
Precaution
