Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Vehicle information display

■ Drive information

Displays drive information such as the following:

Vehicle status information and indicators

  1. Drive information type
  2. Drive information items

Displays the following depending on which drive information type and drive information items were selected in .

  • After start
    • Distance: Displays the distance driven since engine start
    • Elapsed time: Displays the elapsed time since engine start
    • Average vehicle speed: Displays the average vehicle speed since engine start
  • After reset
    • Distance: Displays the distance driven since the display was reset*
    • Elapsed time: Displays the elapsed time since the display was reset*
    • Average vehicle speed: Displays the average vehicle speed since the display was reset*

*: To reset, display the desired item and press and hold the OK meter control switch.

■ AWD operation status display (if equipped)

Vehicle status information and indicators

The illustration used is intended as an example, and may differ from the image that is actually displayed on the multi-information display.

  1. Torque distribution display

Displays the drive status of each wheel in 6 steps from 0 to 5.

    READ NEXT:

     Settings display

    ■ Meter display settings that can be changed Language Select to change the language displayed. Units Select to change the units of measure displayed. Eco Driving Indicator Light Select to e

     Stop & Start system information

    Stop & Start system operation status notification Displays the status of the Stop & Start system with a pop-up display. Stop & Start system settings The length of time of the Stop &

     Multi-information display (7-inch display)

    SEE MORE:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT REAR STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the rear stabilizer link assembly in a vise using aluminum plates. NOTICE: Do not overtighten the vise. (2) Install the nut to the rear stabilizer link assembly stud.

     Refrigerant Pressure Sensor Circuit Short to Ground (P053011)

    DESCRIPTION The air conditioner pressure sensor, which is installed to the high pressure side pipe to detect refrigerant pressure, sends a refrigerant pressure signal to the air conditioning amplifier assembly. The air conditioning amplifier assembly converts this signal to a pressure value accordin

    © 2020-2024 Copyright www.tcorollacross.com