Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Stop & Start system information

  • Stop & Start system operation status notification

Displays the status of the Stop & Start system with a pop-up display.

  • Stop & Start system settings

The length of time of the Stop & Start system will operate when the "A/C" switch of the air conditioning system is on can be set to 2 different levels in of the multi-information display.

Suggestion function (if equipped)

Displays suggestions to the driver in the following situations.

To select a response to a displayed suggestion, use the meter control switches.

■ Suggestion to enable the power back door (if equipped)

If the power back door system is disabled (setting on set to off) and the power back door switch on the instrument panel is operated, a suggestion message will be displayed asking if you wish to enable the power back door system.

To enable the power back door system, select "Yes".

After enabling the power back door system, press the power back door switch again to open or close the power back door.

■ Suggestion to turn off the headlights

If the headlights are left on for a certain amount of time after the engine switch has been turned off, if the headlight switch is in the "AUTO" position, a suggestion message will be displayed asking if you wish to turn the headlights off.

To turn the headlights off, select "Yes".

If the driver's door is opened after the engine switch is turned off, this suggestion message will not be displayed.

■Customization

Some functions can be customized.

    READ NEXT:

     Multi-information display (7-inch display)

     Display and menu icons

    ■ Display Content display area By selecting menu icons on the multi-information display, a variety of driving-related information can be displayed. The multi-information display can also be used

     Changing the meter display

    The multi-information display is operated using the meter control switches. : Select menu icons, scroll the screen and move the cursor : Change displayed content, scroll the screen and mov

    SEE MORE:

     Right Rear Wheel Speed Sensor Circuit Short to Battery (C051212)

    DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control. The speed sensor detects the magnetic fields of the speed sensor rotor as it rotates and outputs a pulse signal. The frequency of t

     Terminals Of Ecu

    TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the I67 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Term

    © 2020-2026 Copyright www.tcorollacross.com PT NL