Toyota Corolla Cross: Fuel Pump (for High Pressure)
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the GTS to the DLC3.
(2) Start the engine. (3) Turn the GTS on. (4) Enter the following menus:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCHARGE FUEL SYSTEM PRESSUR
INSPECTION PROCEDURE 1. INSPECT FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
SEE MORE:
PARTS LOCATION
ILLUSTRATION
*1
BRAKE ACTUATOR ASSEMBLY
- SKID CONTROL ECU
*2
NO. 1 ENGINE ROOM RELAY BLOCK
- ABS NO. 2 FUSE
ILLUSTRATION
*1
PARKING BRAKE ACTUATOR ASSEMBLY LH
*2
PARKING BRA
DESCRIPTION
The airbag ECU assembly has a built-in yaw rate and acceleration
sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) receives signals
from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication.
These DTCs may be store
On-vehicle Inspection
Parts Location
