Toyota Corolla Cross: Flow Shutting Valve
Inspection
INSPECTION
PROCEDURE
1. INSPECT FLOW SHUTTING VALVE (WATER VALVE)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|
1 - 2 | 20°C (68°F) |
22 to 28 Ω |
If the result is not as specified, replace the flow shutting valve (water valve).
READ NEXT:
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
CAUTION: Do not remove the reserve tank cap and air release valve while the engine and radiator assembly are still hot. Pressurized, hot engine coolant
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FAN WITH MOTOR ASSEMBLY
- -
- -
2 NO. 2 WATER BY-PASS H
SEE MORE:
FREEZE FRAME DATA
FREEZE FRAME DATA
(a) When a DTC is stored, the 4WD ECU assembly stores the current vehicle state
as Freeze Frame Data.
HINT:
Freeze Frame Data at the time a DTC is stored:
When the 4WD ECU assembly stores data at the time a DTC is stored, no updates
will be performed
The back door can be
locked/unlocked and
opened/closed by the following
procedures.
WARNING
Observe the following precautions.
Failure to do so may result
in death or serious injury.
■Before driving the vehicle
Before driving the vehicle, make
sure that the back door is fully
closed. If the back
