Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Fail-safe Chart

Toyota Corolla Cross (2022-2026) Service Manual / Power Source & Network / Networking / Cxpi Communication System / Fail-safe Chart

FAIL-SAFE CHART

CXPI COMMUNICATION FAIL-SAFE

(a) When there is a CXPI communication malfunction (communication stop), each load operates as follows.

Power distribution box assembly

Load

Communication Stop with Ignition Switch ON

Communication Stop with Ignition Switch Off

Operation When Communication Returns to Normal

Operation During Communication Stop

Reset Timing

Operation During Communication Stop

Reset Timing

Rear taillight

Interrupted while illuminated: Remains on

Interrupted while not illuminated: Remains off

Ignition switch off or power source reset

Forced off

Simultaneously with operation during communication stop

According to communication signals

Panel light

Forced off

Ignition switch off or power source reset

Forced off

Simultaneously with operation during communication stop

According to communication signals

Rear window defogger

Forced off

Ignition switch off or power source reset

-

-

According to communication signals

Mirror heater

Forced off

Ignition switch off or power source reset

-

-

According to communication signals

Dome cut relay

Forced off

Ignition switch off or power source reset

Forced off

Power source reset

According to communication signals

    READ NEXT:

     Data List / Active Test

    DATA LIST / ACTIVE TEST READ DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when d

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART CXPI Communication System DTC No. Detection Item Link B235587 Power Distribution Box Missing Message

     Power Distribution Box Missing Message (B235587,B235787-B235987)

    DESCRIPTION This DTC is stored when CXPI communication between the power distribution box assembly and windshield wiper relay assembly, headlight assembly RH*1, headlight assembly LH*1 or main bo

    SEE MORE:

     Vanity Light Switch

    InspectionINSPECTION PROCEDURE 1. INSPECT VANITY LIGHT SWITCH LH (VISOR ASSEMBLY LH) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition T3-1 - T3-2

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: The power back door system troubleshooting procedure is based on the premise that the smart key system (for Entry Function) is operating normally. Check the power back door system first before troubleshooting the power back door system. for HEV Model: Click here

    © 2020-2026 Copyright www.tcorollacross.com PT NL