Toyota Corolla Cross: Fail-safe Chart
FAIL-SAFE CHART
FAIL-SAFE CHART
Dynamic Torque Control AWD System|
DTC No. |
Trouble Area |
AWD Warning message |
Fail-safe Operation |
Memory |
Fail-safe Deactivation Condition |
|---|---|---|---|---|---|
|
C120C |
Linear Solenoid Power Supply System Malfunction |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
C1241 |
Low or High Power Supply Voltage |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
C1280 |
Engine Control System Malfunction |
Displayed |
Partially permitted |
Yes |
Ignition switch off |
|
C1296 |
ABS Malfunction |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
C1297 |
Steering Angle Sensor |
Displayed |
Partially permitted |
Yes |
Ignition switch off |
|
C1298 |
Linear Solenoid |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
C1299 |
Cancellation of 4WD Control |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
C1337 |
Diameter of the Tire is not Uniform |
Displayed |
Prohibited |
Yes |
Ignition switch off |
|
U0073 |
Control Module Communication Bus Off |
Displayed |
Prohibited |
Yes |
Communication returned to normal |
|
U0100 |
Lost Communication with ECM / PCM "A" |
Displayed |
Prohibited |
Yes |
Communication returned to normal |
|
U0126 |
Lost Communication with Steering Angle Sensor Module |
Displayed |
Prohibited |
Yes |
Communication returned to normal |
|
U0129 |
Lost Communication with Brake System Control Module |
Displayed |
Prohibited |
Yes |
Communication returned to normal |
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Dynamic Torque Control AWD System
DTC No.
Detection Item
Link
C120C
Linear Solenoid Power Supply System Mal
Linear Solenoid Power Supply System Malfunction (C120C)
DESCRIPTION
When a malfunction has occurred in the linear solenoid power source circuit,
the 4WD ECU assembly stores DTC C120C.
DTC No.
Detection Item
DTC Detectio
SEE MORE:
Operating Light Control Rheostat does not Change Light Brightness
DESCRIPTION The combination meter assembly receives signals from this circuit to adjust the illumination of the combination meter assembly. The combination meter assembly sets the illumination level based on the user operation of the light control rheostat switch. WIRING DIAGRAM
CAUTION / NOTICE
Operation Check
OPERATION CHECK
*a
Automatic High Beam Indicator Light on Combination Meter
Assembly
AUTOMATIC HIGH BEAM OPERATION CHECK
(a) When all of the following conditions are met, the automatic
high beam becomes standby mode and the automatic high beam indicator ligh
