Toyota Corolla Cross: Continuously Variable Transaxle Fluid
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
NO. 1 ENGINE UNDER COVER ASSEMBLY
*2
REAR ENGINE UNDER COVER LH
*3
REFILL PLUG
*4
HIGH TEMPERATURE ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed
ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced dur
SEE MORE:
Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the
table below.
Standard Resistance:
Tester Connection
REGISTRATION / INITIALIZATION / LEARNING HIGH VOLTAGE FUSE ACCUMULATED LOAD HISTORY RESET
HINT: If the HV battery junction block assembly has been replaced, make sure to perform "High Voltage Fuse Accumulated Load History Reset" and then clear the DTCs.
DTC P0A9563 will be stored again if do n
Components
Brake Hold Switch
