Toyota Corolla Cross: Camshaft Timing Control Motor
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY (a) Check Rotation Direction Signal:
(1) Connect the GTS to the DLC3. (2) Turn the power switch on (IG).
(3)
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 ENGINE ASSEMBLY WITH TRANSAXLE
- -
- -
Procedure Pa
INSPECTION CAUTION / NOTICE / HINT
NOTICE:
Make sure the contact surface of the cam timing control motor with EDU assembly (the surface that contacts the No. 2 timing chain cover assembly) is fr
SEE MORE:
UTILITY WRITE VIN/VEHICLE IDENTIFICATION NUMBER
NOTICE:
When the airbag sensor assembly is replaced, it is necessary to write the VIN/Vehicle Identification Number.
Since the VIN information of the airbag sensor assembly is acquired via ECM, it is necessary to first write the VIN of ECM.
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT RADIO SETTING CONDENSER
(a) With the radio setting condenser installed, check that there is
no looseness or other abnormalities.
(b) Measure the resistance of the radio setting condenser
according to the value(s) in the table below.
On-vehicle Inspection
Utility
