Toyota Corolla Cross: Brake Warning Light (Yellow) Remains On

DESCRIPTION

This procedure is for troubleshooting when the brake system warning light (yellow indicator) remains on but no DTCs are output.

The skid control ECU (brake actuator assembly) controls the brake system warning light (yellow indicator) in the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

• The electric parking brake may still operate up to 4 minutes after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 4 minutes or more.
• After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.

  Click here

• When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.

PROCEDURE

(a) Using the GTS, check for Vehicle Control History (RoB).

Click here

HINT:

If vehicle control history (RoB) is stored when the electric parking brake system is suspended, the brake system warning light (yellow indicator) illuminates.

B

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY (RoB) NOTICE: After performing troubleshooting and repair regarding vehicle control history (RoB), clear the vehicle control history (RoB).

A

(a) Perform the Active Test of the combination meter assembly using the GTS.

Click here

(b) Check the combination meter assembly.

OK:

The brake system warning light (yellow indicator) turns on or off in accordance with GTS operation.

OK

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

NG

INSPECT METER / GAUGE SYSTEM

READ NEXT: