Toyota Corolla Cross: Brake Fluid (for Hev Model)
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
CENTER COWL TOP VENTILATOR LOUVER
*2
BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
*3
HOOD
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level.
Brake Fluid:
SAE J1703 or FMVSS No. 116 DOT3
SAE J1704 or FMVSS No. 116 DOT
BLEEDING
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization,
or registration) that must be performed after parts are removed and installed, or
replaced dur
SEE MORE:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY (a) Check Rotation Direction Signal:
(1) Connect the GTS to the DLC3. (2) Turn the ignition switch to ON.
(3) Turn the GTS on. (4) Enter the following menus: Powertrain / Engine / Data List / VVT-iE Motor Dir
DESCRIPTION If the communication line (IMI - EFIO) between the ECM and ID code box (immobiliser code ECU) is stuck high, the ECM will store this DTC.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B279A12
Engine Immobiliser System Circuit Short to Batt
Components
On-vehicle Inspection
