Toyota Corolla Cross: Dcm Activation
DCM ACTIVATION
DCM ACTIVATION
(a) Enter the following menus:
Body Electrical > Telematics > Utility
|
Tester Display
|
|
VIN Synchronization
|
(b) According to the display on the GTS, read the IMEI, ICCID,
software version and VIN.
(c) Turn the ignition switch off.
(d) Turn the ignition switch to ON and wait until only the manual
(SOS) green indicator turns on.
HINT:
If only the manual (SOS) switch green indicator does not turn on
even after 20 minutes elapse with the ignition switch ON, refer to "GREEN INDICATOR
REMAINS OFF".
Click here .gif)
READ NEXT:
ACN CALL END
ACN CALL END
This function terminates the ACN (Automatic Collision Notification)
to the telematics provider. After a collision in which the DCM receives "Collision
Detection Si
CUSTOMIZE PARAMETERS
CUSTOMIZE TELEMATICS SYSTEM
(a) Customizing with the GTS.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized
INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery (mobilephone battery) has been replaced,
it is necessary to perform the Reset Backup Battery Condition procedure.
(a)
SEE MORE:
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the tire
and wheel assemblies measure the tire pressure of each wheel. The measured values
are transmitted to the tire pressure warning ECU and receiver in the vehicle as
radio waves. The ECU compares the measu
DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode.
If power window initialization has not been performed, the auto up and down functions will not operate. WIRING DIAGRAM
Click here
