Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Body

BODY

TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY

(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.

  • Front axle and suspension
  • Drivetrain
  • Rear axle and suspension
  • Brake system
  • Engine mounts
  • Other chassis parts

(b) If necessary, tighten the bolts and nuts on the body parts listed below.

  • Seat belt system
  • Seats
  • Doors and hood
  • Body mounts
  • Fuel tank
  • Exhaust system
  • Other body parts

CLEAN OR REPLACE AIR CONDITIONING FILTER

(a) Remove the air conditioning filter.

Click here

(b) Visually inspect the surface of the air conditioning filter.

(c) If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.

NOTICE:

Some filters are not able to be cleaned.

ROAD TEST

(a) Check the engine and chassis for abnormal noises.

(b) Check that the vehicle does not wander or pull to one side.

(c) Check that the brakes work properly and do not drag.

(d) Bed-in the parking brake pads.

BODY INSPECTION

(a) Check the body exterior for dents, scratches and rust.

(b) Check the underbody for rust and damage.

If necessary, replace any damaged parts or repair any damaged areas.

FINAL INSPECTION

(a) Check the operation of the body parts.

(1) Hood

  • Auxiliary catch operates properly.
  • Hood locks securely when closed.

(2) Front and rear doors

  • Door locks operate properly.
  • Doors close properly.

(3) Back door

Door lock operates properly.

(4) Seats

  • Seats adjust easily and lock securely in any position.
  • Front seatbacks lock securely in any position.
  • Fold-down rear seatbacks lock securely.

(5) Be sure to deliver a clean car. Make sure to check the following:

  • Steering wheel
  • Shift lever knob
  • All switches and knobs
  • Door handles
  • Seats

    READ NEXT:

     Gf1a Transfer Oil

    Components COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 TRANSFER FILLER PLUG *3 TRANSFER DRAIN PLUG

     K120 Continuously Variable Transaxle Fluid

     Components

    COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 REAR ENGINE UNDER COVER LH *3 REFILL PLUG *4

    SEE MORE:

     Diagnosis System

    DIAGNOSIS SYSTEM OBD II (except Mexico Models) When troubleshooting OBD II (On-Board Diagnostics) vehicles, the GTS (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's TCM (Transmission Control Module) can be then

     Operation Check

    OPERATION CHECK CHECK AUTO OPERATION FUNCTION NOTICE: Make sure that initialization has been completed before performing this inspection. Click here The sliding roof auto operation can be customized. Make sure that the auto operation customize setting is set to ON. Click here HINT: When

    © 2020-2025 Copyright www.tcorollacross.com PT NL