Toyota Corolla Cross: K120 Continuously Variable Transaxle Fluid
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
NO. 1 ENGINE UNDER COVER ASSEMBLY
*2
REAR ENGINE UNDER COVER LH
*3
REFILL PLUG
*4
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced du
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced du
SEE MORE:
PARTS LOCATION ILLUSTRATION
*1 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
*2 NO. 1 ENGINE ROOM RELAY BLOCK - IGP-MAIN RELAY ILLUSTRATION
*1 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (FRONT FLOOR)
*2 NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (INSIDE LU
INSTALLATION PROCEDURE 1. INSTALL PIPING CLAMP (for Suction Hose Sub-assembly)
(a) for Gasoline Model: (1) Remove the vinyl tape from the suction pipe sub-assembly and suction hose sub-assembly.
(2) Install a new piping clamp to the suction hose sub-assembly.
NOTICE:
Securely engage
Components
Parts Location
