Toyota Corolla Cross: Accelerator Pedal Sensor
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (a) Connect the GTS to the DLC3.
(b) Turn the power switch on (IG). (c) Turn the GTS on. (d) Enter the following menus:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55606 -
- -
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 ACCELERATOR PEDAL SENSOR ASSEMBLY
78110K
SEE MORE:
DESCRIPTION This circuit sends a charging suspension signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle assembly. Based on this signal, the mobile wireless charger cradle assembly suspends or resumes wireless charging.
HINT: The wireless charging syste
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the L7 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disc