Toyota Corolla Cross: When Voice Recognition Switch is Pressed a Short Beep is Emitted but the Voice
Recognition System does not Start
PROCEDURE
(a) While paying attention to the condition of the spoken voice
command, perform a voice recognition operation.
HINT:
- When the voice command is recognized, the content of the voice command
is displayed in the voice recognition result display area to the right of
the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in
the voice recognition result display area.)
- If an unnecessary word (such as "um" or "ah") is spoken before or after
the recognition word, the system incorrectly recognizes the recognition
word.
- The system cannot recognize voice commands when multiple people are
speaking simultaneously.
- If the speaking speed is too fast or too slow, the recognition rate
may decrease.
- The system may have difficulty recognizing voice commands depending
on the voice quality (such as a hoarse voice due to poor physical condition).
OK:
Voice command is recognized normally.
OK |
|
END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH
CONDITION)
|
NG |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS
TABLE
|
READ NEXT:
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection
or maintenance, performing initialization, registration or calibration may be needed.
Click here
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection
or maintenance, performing initialization, registration or calibration may be n
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection
or maintenance, performing initialization, registration or calibration may be n
SEE MORE:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT: Using the GTS to read the Data List allows the values or states o
DESCRIPTION Refer to DTC P003012. Click here
HINT: Although the DTC titles say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 1).
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P223711 A/F (O2) Sensor Positive Current Contr