Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: In all Modes Noise Occurs in all of the Speakers

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.

Click here

PROCEDURE

1.

CHECK MODEL

Result

Proceed to

for 6 Speakers

A

for 9 Speakers

B

B

GO TO STEP 4

A

2.

CHECK SPEAKER INSTALLATION

(a) Make sure that there are no abnormalities such as looseness or play in the installation of each speaker.

(b) Make sure that there are no abnormalities with each speaker such as the presence of foreign material or tears in the paper of the speaker cone.

Result

Proceed to

No speaker abnormalities

A

Speaker is improperly installed

B

Foreign material is found in the speaker

C

Paper of the speaker cone is torn

D

B

INSTALL THE SPEAKER CORRECTLY

C

REMOVE FOREIGN MATTER FROM THE SPEAKER

D

REPLACE RESPECTIVE PARTS

A

3.

DETERMINE CAUSE OF NOISE

(a) Using the following diagnosis table, determine the cause of noise.

HINT:

  • Confirm that noise is not coming from outside the speaker. Make sure to perform this procedure correctly, otherwise the source of noise may be unclear resulting in the cause being misdiagnosed.
  • When performing the noise prevention procedure, start the inspection from the device with the most noise.
  • Set the radio to a frequency with no broadcast (untuned) so that the noise is more pronounced and easier to judge.

Symptom table:

Condition under which Noise Occurs

Noise Source

A whirring noise occurs when the air conditioner or heater is operating.

Noise from the blower motor

A click sound occurs when the horn button is pressed, and a buzzing sound is heard when pressed and held.

Noise from the horn

A small buzzing sound occurs until the engine stops.

Ignition noise

Clicking sound occurs synchronously with the turn signal blinking pattern

Flashing noise

Noise occurs during window washer operation

Washer noise

Friction sound is heard from the areas the wipers contact.

Noise from the wipers

Clicking sound is heard when depressing the brake pedal

Noise from the stop light switch

Others

Static electricity

Result

Proceed to

The noise source cannot be determined.

A

The noise source can be determined.

B

A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

B

REPLACE THE RESPECTIVE NOISE FILTER

4.

CHECK SPEAKER INSTALLATION

(a) Make sure that there are no abnormalities such as looseness or play in the installation of each speaker.

(b) Make sure that there are no abnormalities with each speaker such as the presence of foreign material or tears in the paper of the speaker cone.

Result

Proceed to

No speaker abnormalities

A

Speaker is improperly installed

B

Foreign material is found in the speaker

C

Paper of the speaker cone is torn

D

B

INSTALL THE SPEAKER CORRECTLY

C

REMOVE FOREIGN MATTER FROM THE SPEAKER

D

REPLACE RESPECTIVE PARTS

A

5.

DETERMINE CAUSE OF NOISE

(a) Using the following diagnosis table, determine the cause of noise.

HINT:

  • Confirm that noise is not coming from outside the speaker. Make sure to perform this procedure correctly, otherwise the source of noise may be unclear resulting in the cause being misdiagnosed.
  • When performing the noise prevention procedure, start the inspection from the device with the most noise.
  • Set the radio to a frequency with no broadcast (untuned) so that the noise is more pronounced and easier to judge.

Symptom table:

Condition under which Noise Occurs

Noise Source

A whirring noise occurs when the air conditioner or heater is operating.

Noise from the blower motor

A click sound occurs when the horn button is pressed, and a buzzing sound is heard when pressed and held.

Noise from the horn

A small buzzing sound occurs until the engine stops.

Ignition noise

Clicking sound occurs synchronously with the turn signal blinking pattern

Flashing noise

Noise occurs during window washer operation

Washer noise

Friction sound is heard from the areas the wipers contact.

Noise from the wipers

Clicking sound is heard when depressing the brake pedal

Noise from the stop light switch

Others

Static electricity

Result

Proceed to

The noise source cannot be determined.

A

The noise source can be determined.

B

A

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

B

REPLACE THE RESPECTIVE NOISE FILTER

    READ NEXT:

     Sound cannot be Heard Sound Quality is Poor only when Replaying USB Storage Device or "iPod"

    WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be n

     Even though Headlights are Turned on Head-unit does not Dim the Display

    WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be n

     Front Door Speaker

    SEE MORE:

     Front Control Rear Air Outlet Damper Control Servo Motor Actuator Stuck Off (B13AB7F)

    DESCRIPTION The No. 2 air conditioning radiator damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 2 air condi

     Driver Identification Method cannot be Set

    DESCRIPTION When a setting assignment using the multi-display is performed, the smart key system (for Start Function), audio and visual system*1 will use the device when performing a search. If detected, settings can be assigned. If there is no detection, it is suspected that the radio and display r

    © 2020-2025 Copyright www.tcorollacross.com PT