Toyota Corolla Cross: Solar Sensor
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the h1 automatic light control sensor connector.
(b) Measure the voltage and resistance according to th
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 INSTRUMENT PANEL SAFETY PAD ASSEMBLY
- -
- -
2 AUTOMATI
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 AUTOMATIC LIGHT CONTROL SENSOR
89120A -
- -
2
SEE MORE:
BLEEDING
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization,
or registration) that must be performed after parts are removed and installed, or
replaced during brake fluid bleeding are shown below.
HINT:
When the cable is disconnected/reconnected to the
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor
sensor RH (A) deviates more than the allowable range from the horizontal axis.
HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination
tester or chassis dynamometer is used with the blind s
On-vehicle Inspection
Bleeding
