Toyota Corolla Cross: Setup
READ NEXT:
Procedure
PROCEDURE
PROCEDURE
1. CUSTOMIZE INTUITIVE PARKING ASSIST SYSTEM
Click here
2. CUSTOMIZE PARKING SUPPORT BRAKE SYSTEM
Click here
3. CUSTOMIZE BLIND SPOT MONITOR SYSTEM
Click he
Before Disconnecting Battery
BEFORE DISCONNECTING BATTERY
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for
HEV Model)
Depending on the "ACC customize"
SEE MORE:
PROCEDURE
1.
CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)
(a) Start the engine and visually check that the generator rotor assembly (fan)
in the generator assembly is operating.
OK:
The generator rotor assembly (fan) is operating.
NG
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the L7 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disc
Customize Parameters
Charging Failure
