Toyota Corolla Cross: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Immobiliser System
|
Symptom | Suspected Area |
Link |
| Engine does not start because no initial combustion occurs |
SFI system |
|
|
Engine does not start but initial combustion occurs |
Proceed to "Engine does not Start but Initial Combustion Occurs" |
|
|
Security indicator light does not blink |
Proceed to "Security Indicator Light Does not Blink" |
|
|
Key cannot be registered | Proceed to "Key Cannot be Registered" |
|
READ NEXT:
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY
(a) Disconnect the I67 transponder key ECU assembly connector.
(b) Measure the resistance and voltage according to the value(s) in the table be
DIAGNOSIS SYSTEM DESCRIPTION (a) The transponder key ECU assembly controls the immobiliser system. Immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
SEE MORE:
DESCRIPTION
The ABS motor relay and pump motor are built into the brake
actuator assembly.
If the skid control ECU (brake actuator assembly) detects a
malfunction in the drive circuit of the pump motor, this DTC is stored.
DTC No.
Detection Item
DTC Detection
DESCRIPTION
Detection Item
Symptom
Trouble Area
Brake Actuator (Skid Control ECU) Communication Stop Mode
Communication stop for "Skid Control (ABS/VSC/TRAC)" is indicated on
the "Communication Bus Check" screen of